Repsol Helen 140

Description
These paraffin based mineral oils are suitable for lubricating steam engine cylinders and maintain permanently stable lubricating film between moving metallic parts, as well as preventing steam from escaping, whether in valves, pistons or seals.
Recommended uses
They are used, according to the growing order of viscosity, for saturated, reheated steam or that with a high degree of reaheating.
Valid for general greasing, gears which are not highly charged and other mechanical elements in which high temperature conditions may occur.
They can be used as heat transfer fluids when used in thermal circuits exposed to open air.
Properties
Very good greasing characteristics.
High flash point.
Low losses through volatility.
Low carbon residues.
Quality level
DIN 51510 – ZA ( 200 grade) and ZB ( 240 grade)
ISO 6743/6 – CKB
ISO 6743/12 - QA
Technical Characteristics -

Available in
185 Kg. drums.
Hazard Identification
This product is not classified as toxic or hazardous under current legislation.
Handling
Certain minimum precautions to avoid prolonged contact with the skin should be taken when handling. The use of gloves, visors or masks is recommended in order to avoid splashes.
Health and safety hazards
Inhalation: Minimum risk of inhalation as it is a non-volatile product.
Ingestion: Does not provoke vomiting. Drink water. Seek medical assistance.
Contact with Skin: Wash with abundant water and soap.
Eyes: Wash with abundant water.
General measures: Seek medical assistance.
Fire fighting measure
No special measures are required.
Fire control: Foams, dry chemicals, CO2, water spray. Do not apply water jet directly as this may cause the product to spread.
Environmental precautions
Danger of physical contamination in the case of spillage (water flows, coastal areas, the ground, etc.) due to its floating capacity and oily consistency which may cause damage to fauna and flora with which it comes into contact. Avoid its penetration into water containers or outlets.
Decontamination and cleaning: Treat as an accidental oil spillage. Avoid spreading by using mechanical barriers and eliminate using both physical and chemical means.